JA 
EN 
ZH 
Features
The diffused face and louvred film keep the source out of the field of view — UGR<16 measured, so the space is lit without the eye being hit by a visible row of emitters.
Sealed to IP65 against dust and low-pressure water jets. It handles kitchens, bathrooms, covered terraces and sheltered façades — anywhere a bare tape would corrode or short within a season.
At Ra>90, the strip reproduces colour faithfully enough for retail, gallery and hospitality work — the applications where a client will notice immediately if it does not.
Anti-Glare Strip DC24V 140LEDs/m IP65 have a number of advantages, especially in settings where illumination might be uncomfortable or impair vision:
-
Highly Cost Effective
Sealing to IP65 removes the most common cause of outdoor strip failure — moisture ingress at the cut point and the connector. That is fewer truck rolls and fewer arguments about who pays.
-
Good Color Consistency
When colour is right, the sign-off happens once. When it is wrong, the whole run comes out — and that cost lands somewhere in the supply chain.
-
Less Waste
Tight cut intervals mean fewer part-reels written off. It is a quiet saving, but on repeat programmes it shows up clearly in the material budget.
-
Fully Certified
CE, UL, RoHS certified, so the consignment clears customs and passes site inspection without a documentation chase. Additional approvals can be arranged where a market requires them.
Product Parameters
| Optical parameter | |
|---|---|
| LED Type: | SMD2835 |
| Color Rendering Index: | >90 |
| CCT Range: | 2700-6500K |
| Irritation Angle: | 120° |
| Light Efficiency: | 12-13Lm/w |
| Lumen Output: | 169-187Lm/m(52~57Lm/ft) |
| UGR: | < 16 |
| Electric parameter | |
|---|---|
| LED Type:Input Current: | 0.6A/m(0.19A/ft) |
| Input Voltage: | DC24V |
| Power: | 14.4W/m(4.39W/ft) |
| Static Electricity: | 2000V (ESD) |
| LEDs/Meter: | 140LEDs/m |
| Size of Section: | 50mm(1.97'') |
| LEDs of Section: | 7LEDs |
Application Scenarios
It can be cut at the marked points every 50 mm. Cutting between those points will disable the section after it, so always trim on the copper pads shown on the tape.
Standard supply is 5 m/reel. Longer and shorter reel lengths, plus pre-terminated leads, can be produced for project orders.
It runs on DC24V constant voltage. Size the driver for the total run length plus headroom, and feed long runs from both ends to keep brightness even.
This version covers 2700K~6500K. Fixed single-CCT options across the 2700–6500 K range can also be produced against a project order.
It is specified at Ra>90. Where a project demands higher fidelity, 95+ versions are available — worth confirming at sample stage so the approved look matches the delivered product.
Yes, for sheltered outdoor use. The IP65 seal handles dust and water jets, which covers covered terraces, canopies and wet rooms. For full immersion, choose an IP68 option.
The minimum bending radius is 200 mm. Bending tighter than that will damage the internal circuit.
Run length depends on the PCB copper weight and the driver location. Share your layout and we will confirm the maximum single-feed length before you order.
Specifications
-
Spectrum Test Reportpdf0.36MB
-
English Specification Documentpdf1.78MB
-
Chinese Specification Documentpdf1.7MB
-
IESoctet-stream0.02MB
Let’s Talk About Your Lighting Project
